Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: SmartSafe
SmartSafe ADAS MAZDA CX-5 Rear Radar Calibration
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
Function Description:
The radar needs to be calibrated in the following cases：
1) The radar sensor is loose or has been replaced.
2) The bumper bracket is loose or replaced.
3）Vehicle structure change/chassis adjustment.
4) The horizontal sensors have been replaced.
5) There is a pre-radar uncalibrated fault code.
Operation guide:
1. Automatically identify the model CX-5 through ADAS calibration entrance VIN.
2. Select "ADAS Calibration".
3. Select "RVM Aiming".
4. Click "YES" after confirming the information.
5. Select "Right Side".
6. Turn on the ignition.
7. Follow the prompts, after the operation is complete, click "Next Step".
8. Follow the prompts, after the operation is complete, click "Next Step".
9. Follow the prompts, after the operation is complete, click "Next Step".
10. Follow the prompts, after the operation is complete, click "Next Step".
11. Follow the prompts, and click "Calibration" after the operation is complete.
12. Turn on the Doppler switch and click "OK".
13. After confirming the radar angle, click "YES".
14. Calibration is successful.
15. Stop the Doppler device.
16. Select "Left Side".
17. Turn on the ignition.
18. Follow the prompts, after the operation is complete, click "Next Step".
19. Follow the prompts, after the operation is complete, click "Next Step".
20. Follow the prompts, after the operation is complete, click "Next Step".
21. Follow the prompts, after the operation is complete, click "Next Step".
22. Follow the prompts, after the operation is complete, click "Calibration".
23. Turn on the Doppler switch.
24. Wait for the program to run.
25. After confirming the radar angle, click "YES".
26. Calibration is successful.
27. Stop the Doppler device.
28. After the left and right radars are calibrated successfully, exit the function and generate an ADAS report.
