top of page

How To Guide:

Source: SmartSafe

SmartSafe ADAS 2019 RAM 1500(DT) DASM Camera + Radar Calibration

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk.  We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide.  Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them.  We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

Function Description:

The following situations require calibrating laser radar


  • Radar sensor is loose or replaced.

  • Loose bumper bracket or replace.

  • Sensor locking bracket is loose or removed.

  • Wheel suspension geometry changes.

  • The rear end inside the front of the vehicle is impacted by an external force.

  • The front camera/ECU has been replaced.

  • The front windshield has been replaced.

  • Structural changes/chassis adjustments.

  • The level sensor has been replaced.

  • There are related fault codes.


Operation guide:

1. Automatically identify the car model through the ADAS calibration entrance VIN and enter the software.



2. After selecting ADAS Calibration Function, click Other Calibration.

3. Select DASM (Driver Assistant System Module) Auto Alignment.

4. Follow the prompts to complete the function.












bottom of page