All Prices Exclude GST

-

Texa USB diagnostic pass thru RC3

Texa USB diagnostic pass thru RC3

$1,850.00Price
Excluding GST

RC3 TEXA’s revolutionary RC3 not only keeps engine RPM and temperature under constant control but also serves as an ECU scanning tool. It therefore allows mechanics to perform two types of test using just the one tool.

 

The RC3 (Revolution Counter 3) interface can read data in three different ways: using an induction clamp with piezoelectric sensors, using a microphone with the residual battery signal, or directly from the OBD socket (on vehicles with the necessary protocol). When plugged into the OBD socket to measure engine RPM and temperature, RC3 reads data directly using EOBD protocol, so there is not even any need to open the bonnet.

 

RC3 can also be used in scan-tool mode; connected to the EOBD socket, it can read the parameters defined by this standard in accordance with new emission control procedures.

  • PROCESSOR SYSTEM
    MB90F591 16MHz

    SERIAL RESOURCES
    1 1.1 USB Connection
    1 RS232 standard connection

    EXTERNAL POWER SUPPLY
    8 ÷ 32 Volt

    WIRELESS CONNECTION
    1.2 Bluetooth technology

    PETROL AND DIESEL DETECTION FROM VEHICLE BATTERY
    12VDC and 24VDC Systems management

    PETROL ANALOGUE DETECTION
    Amp clamp

    DIESEL ANALOGUE DETECTION
    Piezoelectric sensor

    EOBD DETECTION
    ISO9141-2 ISO14230 SAE J1850 PWM SAE J1850 VPW CAN ISO11898

    ENVIRONMENTAL
    Operating temperature: -5°C ÷ +40°C
    Operating moisture: 10% ÷ 80% without condensation
    Storage temperature: -20°C ÷ +60°C

    DIMENSIONS
    155x162x63 mm

    WEIGHT
    800 g.