All Prices Exclude GST


AUTOOL AST605 Car Brake Fluid Bleeder

AUTOOL AST605 Car Brake Fluid Bleeder

Excluding GST
  • 1.The brake fluid is sucked out from the new fluid storage tank through the pump, and continuously pumped into the automobile brake fluid container at a specified pressure. Then on each wheel brake cylinder, drain the old brake fluid in the order specified by the original manufacturer of the vehicle until the new brake fluid flows out.
  • 2.AUTOOL AST605 has Powerful recovery function, it can quickly recover used brake fluid at the same time.The air inlet port has a water separating and filtering device, which can separate the moisture in the air, avoid it mixing with the oil, and ensure the quality.
  • 3.This device has a built-in pressure control system, if the pressure can not be formed or the pump inhales air, the pump will be stopped immediately in order to inject the gas into the vehicle brake fluid container.
  • 4.It can change four sub-pumps oil at the same time, and it can one click replacement. Brake fluid exchanges after pressing the “Start” button for simple operation. And it can operate by one person, easy to use and exchange the brake fluid, it is fast and labour-saving.
  • 5.AUTOOL AST605 is suitable for European, American and Asian car models, it almost can apply for all vehicles. And it suitable for 12V car batteries.
  • AUTOOL AST605 Brake fluid is taken from its container by a pump operating at up to 3.0 bar pressure and is continuously pumped into the brake fluid reservoir. The individual wheel brake cylinders can then be drained of their used brake fluid until the new brake fluid comes through.

    Operation steps:
    Note: no need to start the vehicle for the operation.
    1. Raise the car to a suitable height so the drive wheels are not on the ground.
    2. Connect the four oil pots of the device to the car brake cylinder, and loosen the exhaust screw of the brake cylinder to ensure that oil flows out.
    3. Pour in 2L new brake fluid from the fuel filler port of the equipment, and find the matching model connector to connect to the fuel filler of the brake master cylinder.
    4. Connect to 12V car power and turn on the power switch button.
    5. Press the Vacuum Switch button.
    6. Press the Fuel Switch button to change the brake fluid.
    7. During the oil changing process, look at the car brake oil tank mouth, if the refuel is too slow, press the acceleration switch button on the device to accelerate refueling; if it's too fast, press the deceleration switch button to slow down.
    8. After the oil change is completed, the used oil in the tank of the equipment must be drained clean. If it's not emptied clean, the vacuum pump will be damaged and the oil change operation cannot be performed.

    Technical Parameters:
    Voltage: 220-240V 50/60Hz 
    Maximum power: 35W
    Maximum flow: 1.2 L/min
    Oil shortage protection: support
    Noise: ≦70dB
    Working pressure: 0.6-3.0bar
    Filling hose length: 3.5m
    Host size: 250×185×280mm